Carbon K‐edge spectra of carbonate minerals

Carbon K‐edge X‐ray spectroscopy has been applied to the study of a wide range of organic samples, from polymers and coals to interstellar dust particles. Identification of carbonaceous materials within these samples is accomplished by the pattern of resonances in the 280–320 eV energy region. Carbonate minerals are often encountered in the study of natural samples, and have been identified by a distinctive resonance at 290.3 eV. Here C K‐edge and Ca L‐edge spectra from a range of carbonate minerals are presented. Although all carbonates exhibit a sharp 290 eV resonance, both the precise position of this resonance and the positions of other resonances vary among minerals. The relative strengths of the different carbonate resonances also vary with crystal orientation to the linearly polarized X‐ray beam. Intriguingly, several carbonate minerals also exhibit a strong 288.6 eV resonance, consistent with the position of a carbonyl resonance rather than carbonate. Calcite and aragonite, although indistinguishable spectrally at the C K‐edge, exhibited significantly different spectra at the Ca L‐edge. The distinctive spectral fingerprints of carbonates provide an identification tool, allowing for the examination of such processes as carbon sequestration in minerals, Mn substitution in marine calcium carbonates (dolomitization) and serpentinization of basalts.     

AN EFFICIENT SEQUENTIAL DESIGN FOR SENSITIVITY EXPERIMENTS

In sensitivity experiments, the response is binary and each experimental unit has a critical stimulus level that cannot be observed directly. It is often of interest to estimate extreme quantiles of the distribution of these critical stimulus levels over the tested products. For this purpose a new sequential scheme is proposed with some commonly used models. By using the bootstrap repeated-sampling principle, reasonable prior distributions based on a historic data set are specified. Then, a Bayesian strategy for the sequential procedure is provided and the estimator is given. Further, a high order approximation for such an estimator is explored and its consistency is proven. A simulation study shows that the proposed method gives superior performances over the existing methods.     

聚合物负载的钯-咪唑催化烯烃加氢

A polymer-supported palladium-imidazole catalyst was used to catalyze the hydrogenation of various olefins under mild conditions. The rate of hydrogenation was studied. The effects of factors such as substrate concentration,catalyst concentration,partial pressure of hydrogen and temperature on initial rate of reaction of selected olefins were investigated. A mechanism for the reaction was proposed from the rate equation. The effects of the solvent and structure of the olefin on the rate of hydrogenation were investigated. The catalyst showed good reusability without any leaching of metal from the support. The homologous analog of the polymer-supported catalyst could not be used as catalyst for the hydrogenation of olefins in methanol because there was precipitation of the metal during reaction.     

顺序注射催化光度分析法测定环境水样中痕量钼

基于钼（VI）对碘化钾/过氧化氢反应体系催化作用的反应产物在350 nm处的吸光度与钼在一定浓度范围内呈线性关系的原理,建立了灵敏的顺序注射催化动力学光度分析新方法。方法的线性范围是2~300 μg/L,方法的检出限（3s）为1.1μg/L,相对标准偏差（RSD）为 0.6%（n=11）。 每次测定仅消耗100μL试样,75μL KI和125μL H2O2 , 对4个不同水样的钼测定回收率在95.2%~105.2%之间。顺序注射催化动力学光度分析测定环境水样中痕量钼的方法是一种快速、准确的新方法。     

On-Surface Synthesis of Cumulene-Containing Polymers via Two-Step Dehalogenative Homocoupling of Dibromomethylene-Functionalized Tribenzoazulene

Cumulene compounds are notoriously difficult to prepare and study because their reactivity increases dramatically with the increasing number of consecutive double bonds. In this respect, the emerging field of on-surface synthesis provides exceptional opportunities because it relies on reactions on clean metal substrates under well-controlled ultrahigh-vacuum conditions. Here we report the on-surface synthesis of a polymer linked by cumulene-like bonds on a Au(111) surface via sequential thermally activated dehalogenative C−C coupling of a tribenzoazulene precursor equipped with two dibromomethylene groups. The structure and electronic properties of the resulting polymer with cumulene-like pentagon–pentagon and heptagon–heptagon connections have been investigated by means of scanning probe microscopy and spectroscopy methods and X-ray photoelectron spectroscopy, complemented by density functional theory calculations. Our results provide perspectives for the on-surface synthesis of cumulene-containing compounds, as well as protocols relevant to the stepwise fabrication of carbon–carbon bonds on surfaces.     

气体扩散耦合顺序注射光度分析法测定葡萄酒中的二氧化硫*

依据在微碱性条件下,亚硫酸根离子可与孔雀绿溶液发生加成反应并使其褪色的原理,建立了气体扩散耦合顺序注射分光光度法测定葡萄酒中二氧化硫的新方法。当接收液流速为1.2mL/min和4.2mL/min时,方法的线性响应范围分别为1.0-5.0μg/mL和5.0-50.0μg/mL,方法的检出限为0.33μg/mL,相对标准偏差（RSD）≤0.43%,对葡萄酒样中二氧化硫测定的加标回收率为98.7%-104.7%。     

Automated in-syringe single-drop head-space micro-extraction applied to the determination of ethanol in wine samples

A novel approach of head-space single-drop micro-extraction applied to the determination of ethanol in wine is presented. For the first time, the syringe of an automated syringe pump was used as an extraction chamber of adaptable size for a volatile analyte. This approach enabled to apply negative pressure during the enrichment step, which favored the evaporation of the analyte. Placing a slowly spinning magnetic stirring bar inside the syringe, effective syringe cleaning as well as mixing of the sample with buffer solution to suppress the interference of acetic acid was achieved.     

聚酰亚胺薄膜的电致发光和光致发光

测量了氙灯辐照后聚酰亚胺(PI)薄膜的光致发光(PL)强度、PL谱和氙灯辐照后直流高电场下PI薄膜的电致发光(EL)强度、EL谱、XRD谱和吸收光谱,研究了其EL、PL特性与微观结构的关系.结果表明:PI薄膜的PL强度随测量时间呈指数衰减,EL强度随场强呈指数增长;辐照39 h后,PI的预击穿场强为2.56MV/cm,...     

一种短程无衍射激光图像定中算法

针对短程无衍射激光图像特点,提出了一种由亮度梯度确定图像中心的方法。利用光斑图像边缘的亮度梯度,设定图像二值化阂值范围,根据二值化结果确定光斑图像边缘点,对于各边缘点,利用圆上两点直径最长的原理,通过直径的中点确定圆心,求出均值,作为光斑图像的中心。本方法速度快、精度高,适合于实时性要求较强的应用场合,已经在实际应用中...